How I made the claws of X-23 and Wolverine

At the request of , I upload how did the claws of wolverine and x-23.


The material I used was white methacrylate of 0,3 mm.
I used a template made earlier in a sheet , put the template on top of the methacrylate and marked with a pen the figure. I then cut and I to sand the claws. For painting I used a silver Montana spray and for not damage the claws grip part, I used black sticky tape.


In this way, the claws don't fall from the hands and them you can open and close, and they seem that they go out of the skin.